check vavel for my snorkel

[rubicon500kid]

would this work

[attachment deleted by admin]

[GSPKurt]

Check with a plumbing supply house. See if they have a 2" PVC check valve. How will you get the water out of it when it gets in?     Maybe mount it horizontally and have a T just before the check valve with a ball valve on the drop leg. Just don't forget to close it again before riding.

[jwscroll]

What snorkel is it for? The crank? Not good to mix metal parts with plastic parts, something about the fit.

[rubicon500kid]

its for the snorkel

[jwscroll]

Not sure you want to put a check valvein your snorkle, it will restrict your airflow if the airbox creates enough suction to even open it.

[rubicon500kid]

ok for get it then

[jwscroll]

Hole Saw.

[attachment deleted by admin]

[jwscroll]

1 1/2 in. Flex connector, top one connects pvc to thickwalled white spa hose which I pushed in between the fender and the oil cooler.
Bottom flex I cut open on one side and wrapped it around pipe for two reasons.1 to prevent the snorkel from falling back down the hole, & 2 to protect the pipe from the bracket.

[attachment deleted by admin]

[jwscroll]

1 1/2 in. 90 degree pipe connector at the end of the flex hose, notice where I pushed the hose thru. Stay between the inner fender and the oil cooler. Doing it this way did prevent me from reattaching the little rivet right there.

[attachment deleted by admin]

[rubicon500kid]

ok cool now at the top i was just going to run a full pvc cuz i want it to be inter changebul from big to small and its a twist on will it still work with that

[rubicon500kid]

also what did u use to seal it up im using pvc cement and gasket type thing that pervents water to get in now what type of heat sheald r u useing

[jwscroll]

I got some metal repair tape from Autozone. I haven't had any problems yet, just be sure the pipe is snug against the frame.
At the top of the flex connect on the bracket you'll notice a thin white line, this is the threaded connector I used to accomplish what you want to do. I glued it up with pvc primer then cement, but primer not really necessary. Be sure to use some teflon tape on the threads, do not put a major amount of torque on this connection just snug it down. Too much torque and you will break yuor glue connection and make it nearly impossible to remove.

[rubicon500kid]

dose any one know if there is a wrap that is heat risitn where it will deflect the heat away from my snorkel