How to remove?

[Thunderdually]

My son has a go-cart with a Dekni Japanese regular carburetor. It has four bolts in the carb bowl. 2 have the hex head  with the center  point and 2 that just have a round head on them.  The hex is no problem but I can’t figure out how to get the other two screws out.  Any one have any ideas on how to remove them?

[svtbolt04]

Can you post a pic

[cr500pro]

ive removed  screws like that from carb. bowls,this way 1 get pressure pliers that r needle nose. n try to grip the bolt n unscreww it...2 with a lite hammer hit the bolts firmly on the head but not to hard,it will lossen it up n ...3 with a flat head screw driver,n hammer hit the bolt on the edge in a counter clock wise direction as if u were unscrewing it..good luck pal

[Andy9933]

I usually grind a slot into them and use a flat head screwdriver. If that's not possible, then you will have to drill the head off. Most likely, you will have to replace the screws either way.

[svtbolt04]

If you're able to grab the sides with some alternative lifestyle cutters, grab hold and twist. Usually works best vertical.

[Thunderdually]

Thanks for the replies but this post is a year old...  I did get the bolts out using the method Andy described.....

[Andy9933]

That's funny, I never pay attention.