YFZ WONT RUN

[The hyrbid kid]

OK So my freind has a yfz and it will crank and run but when ever u start to let the clutch out it dye's..And were not stalling it it when ever u start to put it under a load it die's...
and my freind said its a bad valve but idk i figured you'll could give us some help thanks...
Mabe the stator??

Thanks
Tyler

[53yfz450]

try checking the sensor that runs onto the cluth lever if he still has it connected

[rubicon500kid]

mine dose the same stuff unless i give it alot of gas
what sensor are you talking about ? is there a way you can bypass it ?

[53yfz450]

yes there is. it goes into the vlutch perch. cut the wires and connect them.

[The hyrbid kid]

already tryed this still isnt working..

[Ride1Rob]

Could it be his neutral switch?

[53yfz450]

try to check the TPS switch in the throttle housing and check to see if the wires are connected from the carberator leading to it.

[The hyrbid kid]

Well its fixed i guess some wire under the front fender was unhook..
he called me and told me its working fine so idk.
he said he was checking wires and found one unhooked so its good to go now..

So everyone wensday night at sunshine..