Thanks will take it apart and look

Where can you find sprockets, larger tires or something to speed this this thing up? My 6 year old will not ride it because it is to slow!!!! Rev limiter has it at about 11mph

removed my swaybar before we went to Tn last march. would not put it back. Wish i would have left spacers off. now have to replace the rear studs to remove the spacers

Thanks for the information. Update to the rhino stereo project.

I think titles are a good thing. The $30 to the state s_cks but have your trailer stolen and resold on a bill of sale and someone purchases a tag for it you will want the state to start titling trailers.

Opinions on what you may like and dependability? Under dash will not work to much water

Shawn your right, just looked at my paper. That what i get for reading some of these threads and drinking to much budweiser.

Wow just got the rhino back from the update. They put 2" spacers on the rear instead of 1" as the paperwork I got said. Now the 27" ITP stick out of the flare about 21/2". If you have update done have them give you the video to watch, free helmet up to $100. Got a cool helmet for my daughter.

Thanks we enjoy it. I do not notice the extra suspension travel at the ranch. Got into some rock crawling and creeks in tn. Noticed it then.

croom about 40 minute drive.

Manager is very friendly and the logging is suppose to finish in December. They are clearing the passages on some of the older trails also. It is awsome riding now but when everything grows back wow what scenary there will be. I hope someday they stop building homes and closing areas like this.

dust dust dust. sand sand sand. Need I say more. It is dry when you cannot find water in the deadends

more

more pics

Awsome riding and a lot of rocks, cheap but trails not marked very well.

Just registered

The dealer will install 2 one inch wheel spacers on the rear free of charge. They are not calling it a recall just a maintenance upgrade for rollover safety. You will get a letter in the mail. Removing the sway gar is suppose to give you more suspension travel. The sway bar on the rhino is short, the one on my 09 ranger allows more travel. We will not be back to the ranch until May going to Callalantee just outside Bristol Tn in  2 weeks

We love ours also. Goin to remove the swaybar myself before takin to Yamaha for the free wheel spacer. Dont want them to keep it if I dont like the change in the suspension Look for us sometime at RR. Cant miss us have not seen one like ours at the ranch. Flames and snake skin print in the plastics

Marions atv out of Louisiana. You can find them on ebay. The post will say low cost low verhead. i bought a set of ITP 108 with 26" mudlights with freight close to $500

check out callalantee atv and campfround just outside Britol tn. we are planning a trip there at the end of April. No rules other than helmets under 16. Open 24 hours

sounds like tank not venting creating a vacuum

Support the hub and drive them out with a brass punch and hammer. Do not just support outside edge you will damage the hub. I have replaced the bearings on my 4x4 rancher and my 2x4 rancher and the front bearings on the z400 that way.

building pressure in the casing where the pull rope is located. Builds enough to unseal the rope handle. cannot find any vent tubes that may be blocked. The engine vent is blowing plenty into the air box. Any suggestions?

Going tomorrow. You may need a life jacket instead of mud tires LOL

The registration office in Plant City told me all atvs sold by anyone after 2000 must have a title. If they did not come with a title the previous owner can apply for one with a bill of sale. I purchased a 1996 lt 160 and the owner got me a title.