|
|
Show Posts
|
Pages: [1] 2 3 4
|
16
|
General / Tech Corner / Re: Exhaust with out rejjeting
|
on: December 13, 2005, 05:06:59 PM
|
change jet, i was told not to change the jet by the instructions and am paying for it. ran too lean and froze my rings inside my piston luckily its only a 30.00 mistake.
|
|
|
17
|
General / Tech Corner / Re: dvx400(z400) cdi problem
|
on: December 13, 2005, 04:54:36 PM
|
rings were stuck, i ordered a new set of rings will be putting together when the rings come in. The old rings tested bad when i check the ring gap where the ring meets together.
|
|
|
18
|
General / Tech Corner / Re: dvx400(z400) cdi problem
|
on: December 12, 2005, 04:13:03 PM
|
its not my cdi, did a compression test on it and turned only 45 psi , but its only the rings (36.00, and luckily they siezed inside the piston and not outside).
|
|
|
20
|
General / Tech Corner / help with my new white Bros Pro aluminum exhaust.
|
on: December 05, 2005, 08:55:11 PM
|
I just got a white bros Pro Aluminum Full Exhaust and Header for my dvx400. it runs fine with airbox lid on and stock jet (130) but I want to run it with the airbox lid off. i have a 160 jet that came with it, i have installed it and ran it with the pipe but it back fires when i give it gas. The instructions said to run the 160 jet when the lid was off. It also says to tune the air screw if theres too much gas or air in the mixture. I just thought id get a little advice before i go screw with things. i have not had time to see if the stock jet would work with the lid off, but i think it would run lean.
|
|
|
24
|
General / Tech Corner / Re: DVX 400 likes to idle at 6000 rpms!!!!
|
on: December 03, 2005, 12:26:45 PM
|
its not my carb i took it apart and took checked all my cables,choke, jets and float, needle, etc!!! its got to be the cdi!! now i have to test it and dont know where to do that, or know anyone with a z400, kfx, or dvx.
|
|
|
25
|
General / Tech Corner / Re: DVX 400 likes to idle at 6000 rpms!!!!
|
on: December 02, 2005, 10:43:05 PM
|
tonight i cant do much since the neighbors dont appreciate my bike, let alone it idleing 6000 rpms while i mess around with cables, and etc.
bluesman i got the pm, i will call you tommorow if i cant figure it out.
Most likely i will go over atvtrailers place tommorow if hes not doing anything and see whats going on.
Thanks hollywood, i will keep you up to date on what i try, and narrow it down some more.
|
|
|
|
Loading...
| |