Title: riding wheelies on a raptor Post by: 350_raptor on April 02, 2005, 10:14:24 PM does anyone have any tips on riding wheelies on a yamaha raptor 350 ?
Title: Re: riding wheelies on a raptor Post by: GSPKurt on April 03, 2005, 12:21:24 AM Yup, HOLD ON!!! ;)
Title: Re: riding wheelies on a raptor Post by: 350_raptor on April 03, 2005, 01:46:30 AM when are you going to send them to me
look i can ride them but not far at all because i am not heavy enough so i put my foot in the back swing bar or whatever then i use my left foot to balance but i always push the throttle to much or less but i wanna have some tips so i can be able to it is a stock 350 raptor and could you make me a list of the best thing to make my raptor faster and better if possible but mainly help on riding wheelies thanks Title: Re: riding wheelies on a raptor Post by: Chuck_Norris on April 03, 2005, 10:56:03 AM one thing to remember is the front comes up with torque, if you remove the torque you stop the momentum unless you go over center. simply put become good friends with the rear brake pedal, as the front end comes up tap the rear brake pedal and it will go right back down and keep you on the bike well that is unless you have to much forward momentum and go over the handle bars. you'll want to find the balance point and work from there. Good luck and be safe
Title: Re: riding wheelies on a raptor Post by: LakeMaryKid on April 03, 2005, 11:20:14 AM ok first, overcome the fear of falling or flipping when you go too far back. First get in some grass and perposly rev it up and dump the clutch so you go back onto the grab bar a few times and hold on! Don't bail! Then Put your left foot in the grab bar, and your right foot still on the right peg, and be ready to hit the rear brake pedal. Now it is best to learn in second gear becuase it is harder to run out of gear. First gear revs out quick and its harder to learn in that gear. Now yes you will be going faster in second gear, just be careful and know your limits.
Make sure your rear tires are aired the same pressure or else you will drift to one side. The brake and the clutch are your friend! It is easier to go to far at first and work your way back down to the balance point, but starting to low you will only be doing a powerwheelie and you will eventually run out of gear. The balance point will feel like your about to go too far back but you wont. Also, do not be blipping the throttle once you get the balance point, pick a steady place and keep your thumb/throttle there. Now if your about to go too far back let off the throttle, if that isnt enough, BARELY and i mean BARELY tap the rear brake. Tap it too hard and youll be chewing on bars/pavement/grass. I learned that one the hard way. Title: Re: riding wheelies on a raptor Post by: 350_raptor on April 03, 2005, 11:49:13 AM ok look i put my right foot in the grab bar and then i use my left one out to hold my balance is that right?? or is that not right so i am supposed to put my left foot in the grab bar and then my right on the right pedal for the back brake?? then brake when it goes to far or what??
Title: Re: riding wheelies on a raptor Post by: 53yfz450 on April 03, 2005, 11:58:13 AM i put a pipe air filter kit and jetting on mine and that thing can wheelie i almost flip the quad at a start of a race. i think hmf is the best pipe for the 350.
Title: Re: riding wheelies on a raptor Post by: o4250 on April 03, 2005, 12:19:56 PM I just learned them and there really easy, But I can say this if your In GRASS and you flip back nothing will happen but your grab bar diggin into the ground and slowing you down. It will leave ruts!
Title: Re: riding wheelies on a raptor Post by: LakeMaryKid on April 03, 2005, 12:49:05 PM Quote ok look i put my right foot in the grab bar and then i use my left one out to hold my balance is that right?? or is that not right so i am supposed to put my left foot in the grab bar and then my right on the right pedal for the back brake?? then brake when it goes to far or what?? Left foot in grab bar and right foot on peg/rear brake and yes when you feel your going to far, let off the gas and if need be hit the rear brake. Title: Re: riding wheelies on a raptor Post by: 350_raptor on April 03, 2005, 12:54:15 PM thanks a lot man but does anyone have any suggestions on putting aftermarket parts on my 350 stock raptor if so like give me a quote of how much it will be and how it will make my quad please thanks a lot man for helping me out
Title: Re: riding wheelies on a raptor Post by: Chuck_Norris on April 03, 2005, 07:44:24 PM Quote thanks a lot man but does anyone have any suggestions on putting aftermarket parts on my 350 stock raptor if so like give me a quote of how much it will be and how it will make my quad please thanks a lot man for helping me out post your question in the Tech section for more response Title: Re: riding wheelies on a raptor Post by: raptorboy954 on April 03, 2005, 07:57:13 PM hey i just learned to ride wheelies through all gears on my rappy and its all about balance using the brake and gas. once u learn the basics of the brake and gas. then u can start to change gears but be careful. take it easy and know ur limits
raptorboy Title: Re: riding wheelies on a raptor Post by: Chuck_Norris on April 04, 2005, 06:41:00 AM Quote know ur limits raptorboy [smiley=ThumbsUp.gif] |