|
Title: need help FAST! Post by: Roostin300ex on November 19, 2005, 07:44:26 PM hey, how do you change the rear brake pads on an atv. like where do you bleed the lines from, if you need to? and if you need to do everything in a certain order. i dont have a manual for this quad. help please please please. just general directions!!!!!
thanks Title: Re: need help FAST! Post by: 96 warrior on November 19, 2005, 08:15:42 PM not sure about your bike but mine is
2 bolts on right side of caliper that hold break pads in, take those out, then take off the bolts that hold caliper on take out pads then there will be a little piston, use a c-clamp and push that back put new pads in and put everything back together Title: Re: need help FAST! Post by: Bigscrb15 on November 19, 2005, 08:19:51 PM If you are just changing pads you shouldnt have to bleed the system. I just changed all mine today. On my Vinson, I actually took off the entire caliper and caliper mounting plate, it was alot easier.
|