ATV Florida Forum

General => Tech Corner => Topic started by: TurboBanshee_kid on November 04, 2005, 09:49:29 PM



Title: Need some help with a nut on the Banshee cylinders
Post by: TurboBanshee_kid on November 04, 2005, 09:49:29 PM
Need some help with a nut on the banshee's cylinders. It was strip when I was taking the cylinders off for porting. How can i get it off?

Thank you guys so much :'( I want the porting :'(

[attachment deleted by admin]


Title: Re: Need some help with a nut on the Banshee cylinders
Post by: TurboBanshee_kid on November 04, 2005, 09:50:54 PM
More

[attachment deleted by admin]


Title: Re: Need some help with a nut on the Banshee cylinders
Post by: cutngrs on November 04, 2005, 10:03:05 PM
pull the head off  and the other cylinder  off   this should give you a nuff room to use a pair of vise grips   i have set of cylinders that are all ready ported with big bore sleeves but they are only at a 64.75 bore i have pistions too  all new never put on since done

[attachment deleted by admin]


Title: Re: Need some help with a nut on the Banshee cylinders
Post by: TurboBanshee_kid on November 04, 2005, 10:05:49 PM
Hey thanks very much!


Title: Re: Need some help with a nut on the Banshee cylinders
Post by: Chillinthemost on November 04, 2005, 11:10:31 PM
Make sure you use a 6 point socket