ATV Florida Forum

General => Tech Corner => Topic started by: rubicon500kid on October 26, 2005, 08:59:33 PM



Title: tie rods on a rancher
Post by: rubicon500kid on October 26, 2005, 08:59:33 PM
How do i know if they tight or loose  and how do i tighten them.


Title: Re: tie rods on a rancher
Post by: kodiak-jason on October 27, 2005, 01:01:49 AM
The tie rod it self won't be loose. The tie rod ends will be. Check those they should'nt have any play. Jason


Title: Re: tie rods on a rancher
Post by: rubicon500kid on October 27, 2005, 01:36:19 AM
like if i can twist the end is it loose


Title: Re: tie rods on a rancher
Post by: kodiak-jason on October 27, 2005, 08:31:49 AM
Like it should twist. You shoud not have movement up & down or side to side. Jason


Title: Re: tie rods on a rancher
Post by: rubicon500kid on October 27, 2005, 01:28:49 PM
oh ok there good then thanks


Title: Re: tie rods on a rancher
Post by: NP04Foreman on November 01, 2005, 11:03:42 PM
they do have a recall for your year rancher... id get them done just incase... thats up to you though


Title: Re: tie rods on a rancher
Post by: jwscroll on November 03, 2005, 04:56:28 AM
Check with Honda about the recall, only a certain number of bikes are getting called for the tie rods. Honda cuaght the problem after a few thousand units. If you have an electric shift and your having problems with the readout blinking, check about getting the angle sensor replaced, Honda did a quiet recall on those cause of a faulty manufacturer.