ATV Florida Forum

General => Open Discussion => Topic started by: Vumad on August 12, 2009, 07:08:22 PM



Title: Warrior 350 AM chain roller
Post by: Vumad on August 12, 2009, 07:08:22 PM
The bushing for my chain roller is gone. I went to buy a new one. They told me the After Market chain roller would work. It doesn't not fit over the frame pin. The book definitly has the part listed for my bike. I'm wondering if the way to install the part is to cut out the frame pin or something. Barney's wasn't able to provide information on how to use the part they sell. Go figure...

This is the part they sold me... http://www.motoworldracing.com/MSR-Chain-Roller.html

Any info will help. I think I need to cut out the frame pin, which is ok because it's damaged, but I don't want to do that and then find out it wont work. I could still use a stock bushing, but they don't last very long.

Thanks.


Title: Re: Warrior 350 AM chain roller
Post by: figure843 on August 20, 2009, 02:18:09 AM
yes. cut pin off flush. i believe i used a 1/4 bolt to go through bearing and frame on both of my warriors. i use all balls rollers. any roller will probably work.