|
Title: Warrior Starting Problem Post by: Two-Fast Yfz 450 on January 02, 2008, 08:09:55 PM I cant get my warrior to start it turns ove but will never start it has a new cdi box and a new stator i need help to get it to start thanks
Title: Re: Warrior Starting Problem Post by: TRX450R_Racer on January 02, 2008, 09:19:19 PM Do you have spark? Do you have fuel? Do you have compression?
Title: Re: Warrior Starting Problem Post by: k.p. on January 02, 2008, 09:20:36 PM happened to me too
turns out some of my wires were loose...try tightening all your conections. Title: Re: Warrior Starting Problem Post by: Two-Fast Yfz 450 on January 02, 2008, 09:24:10 PM It has fuel and it has compression and it has some spark but not that much. I had put a dyno ignition box on the bike and it had fried the electrical system and stator. I got it fixed and it ran so than we got a new dyno ignition box and it fried the stator here agian but i put on a new stock cdi box and replaced the stator but now it wont start
Title: Re: Warrior Starting Problem Post by: TRX450R_Racer on January 02, 2008, 09:38:29 PM Check the ground for the coil.
Title: Re: Warrior Starting Problem Post by: Two-Fast Yfz 450 on January 02, 2008, 09:45:47 PM Well when it went out i was actually racing it and than i took it home and put in the new stator and cdi box and now it doesnt drive.lol
Title: Re: Warrior Starting Problem Post by: lugnuts on January 02, 2008, 11:33:58 PM what kind of stator did you get ie:factory,rick stator I only ask because I just had the same problem with a warrior and it was a new stator from rm stator the new stator was bad had to get another one
there is a ohm test you can do to check the stator to see if its ok also make sure battery is fully charged low voltage can cause erratic/weak spark steve |