|
Title: IS REJETTING A MUST WHEN ROMVING BAFFLE? Post by: bigwake on July 04, 2007, 09:22:23 PM I HAVE AN 03 YZ450F..STOCK EXHAUST..I WANT TO REMOVE THE BAFFLE AND I HEAR THAT I MUST RE JET..IS THAT TRUE? AND CAN I GET AWAY WITH BUYING THE INDIVIDUAL JETS INSTEAD FO A KIT?..ANYONE WHO CAN HELP ME, I WOULD APPRECIATE IT VERY MUCH!..THANX-JOSH
Title: Re: IS REJETTING A MUST WHEN ROMVING BAFFLE? Post by: quadracer1992 on July 04, 2007, 09:31:31 PM Im pretty sure you can buy induvidual jets, and you might need to re-jet considering you are getting more exhaust flow.
Title: Re: IS REJETTING A MUST WHEN ROMVING BAFFLE? Post by: bigwake on July 04, 2007, 09:37:24 PM ok..thanx!..-josh
Title: Re: IS REJETTING A MUST WHEN ROMVING BAFFLE? Post by: Captain The Morgan on July 04, 2007, 09:42:39 PM It depends on your current jetting. However, if it's a stock pipe, it shouldn't have enough packing to warrant a re-jet. You should be able to use the carb adjustment to make up for any augmentation of the packing.
Title: Re: IS REJETTING A MUST WHEN ROMVING BAFFLE? Post by: quadracer1992 on July 04, 2007, 09:52:51 PM I used to have a little 125 breeze and we put a new end peice on the slip on and we had to re jet it.
Title: Re: IS REJETTING A MUST WHEN ROMVING BAFFLE? Post by: bigwake on July 04, 2007, 09:54:04 PM so was that an after market peice you put on? because i am only removing stock baffle from a stock pipe..thanx
Title: Re: IS REJETTING A MUST WHEN ROMVING BAFFLE? Post by: Chuck_Norris on July 04, 2007, 10:02:01 PM you'll know as soon as you start riding it if additional jetting is required, might want to consider uping the pilot to a 45 or a 48 with the air box lid off. idle air screw 1.5 turns out needle on the 4th clip and a 165 to 168main. That should get you close if not a tad bit fat. get a few spark plugs and read them with each adjustment. your are looking for a tan kernel.. PS try out the Tech section. there is alot of good stuff in there
|