well i have an 06 yfz...yesterday my bike started...and today i went to install a new starter button to replace the factory mounted one with the lights n all that stuff...all i did was cut the wires that go to the (red slider)on/off switch and tied the two together so that its always on...then i tested to make sure it works...and my bike turns over but wont fire...and i put it back to stock and it still wont start...but still turns over...i checked to see if i have spark and i do..and i put a new spark plug in as well..any suggestions or anything that could help? thanks ahead of time
Not being a wise ass, try turning the gas on?
lol yea it was on...but the thing was clogged...i had to pull it out of the gas tank n clean it out...thanks though
I BET YOU BLEW A IGN FUSE
did you get it running?
yea i got it running :) but now i split the cases open :'(
Quote from: #21yfz on April 28, 2007, 12:27:59 PM
yea i got it running :) but now i split the cases open :'(
How'd you do that?
chain fell off and shot forward...i didnt realize i had the rear spocket on the wrong side of the hub part that holds the sprocket.. :banghead.gif