|
Title: YFZ WONT RUN Post by: The hyrbid kid on December 11, 2006, 03:28:13 PM OK So my freind has a yfz and it will crank and run but when ever u start to let the clutch out it dye's..And were not stalling it it when ever u start to put it under a load it die's...
and my freind said its a bad valve but idk i figured you'll could give us some help thanks... Mabe the stator?? Thanks Tyler Title: Re: YFZ WONT RUN Post by: 53yfz450 on December 11, 2006, 03:47:20 PM try checking the sensor that runs onto the cluth lever if he still has it connected
Title: Re: YFZ WONT RUN Post by: rubicon500kid on December 11, 2006, 04:08:33 PM mine dose the same stuff unless i give it alot of gas
what sensor are you talking about ? is there a way you can bypass it ? Title: Re: YFZ WONT RUN Post by: 53yfz450 on December 11, 2006, 04:23:45 PM yes there is. it goes into the vlutch perch. cut the wires and connect them.
Title: Re: YFZ WONT RUN Post by: The hyrbid kid on December 11, 2006, 04:41:14 PM already tryed this still isnt working..
Title: Re: YFZ WONT RUN Post by: Ride1Rob on December 11, 2006, 05:34:31 PM Could it be his neutral switch?
Title: Re: YFZ WONT RUN Post by: 53yfz450 on December 11, 2006, 05:36:34 PM try to check the TPS switch in the throttle housing and check to see if the wires are connected from the carberator leading to it.
Title: Re: YFZ WONT RUN Post by: The hyrbid kid on December 11, 2006, 10:08:55 PM Well its fixed i guess some wire under the front fender was unhook..
he called me and told me its working fine so idk. he said he was checking wires and found one unhooked so its good to go now.. So everyone wensday night at sunshine.. |