|
Title: Will these work? Post by: klutchbuster400 on July 16, 2006, 10:44:55 PM http://cgi.ebay.com/ebaymotors/Pro-Taper-Carmichael-SE-Bar_W0QQcmdZViewItemQQcategoryZ34284QQihZ002QQitemZ4623760105
I'm not sure if they work the same as Atv bend, will i feel a difference? Bad/ good? Title: Re: Will these work? Post by: Chevy1500z71 on July 16, 2006, 10:47:28 PM go to pro taper.com and check the chart. they will fit ofcourse. your just gona want to check the measurments based on whats comfterble to you
Title: Re: Will these work? Post by: klutchbuster400 on July 16, 2006, 10:56:43 PM go to pro taper.com and check the chart. they will fit ofcourse. your just gona want to check the measurments based on whats comfterble to you I couldnt find anywhere to buy it right off of the site, and rockymountain didnt have black so i loooked on ebay and found that, The measurements seem ok to me though.Title: Re: Will these work? Post by: Fox17 on July 16, 2006, 11:07:02 PM i found the spec chart in a rocky mountain catalog. here are the carmichael dimensions: width-31.50" height-3.00" and pull back-2.17". here are the dimensions for a 400ex: width-31.10" height-5.59" and pull back-3.54". hope this helps. the only really noticeable difference is the height is 2.59" different and pull back is close 1.50" different. the 400ex is probably close to the z400. the warrior/banshee/blaster is the same as 400ex.
|