ATV Florida Forum

General => Open Discussion => Topic started by: bruins on June 21, 2006, 09:29:41 AM



Title: how to drain water from a 2006 suzuki vinson
Post by: bruins on June 21, 2006, 09:29:41 AM
anyone know how to drain the water from a 2006 suzuki vinson?


Title: Re: how to drain water from a 2006 suzuki vinson
Post by: Toomey on June 21, 2006, 09:40:15 AM
The radiator fluid or you drove the quad into too deep water?


Title: Re: how to drain water from a 2006 suzuki vinson
Post by: SWAMP_DONKEY on June 21, 2006, 09:48:28 AM
anyone know how to drain the water from a 2006 suzuki vinson?

From where? CVT, engine??


Title: Re: how to drain water from a 2006 suzuki vinson
Post by: Joedirt on June 21, 2006, 03:08:46 PM
Zip Ties and Duct Tape!!!......Water from where?


Title: Re: how to drain water from a 2006 suzuki vinson
Post by: Da_Mtg_Man on June 21, 2006, 03:16:52 PM
If it's the CVT it shopuld be the same as the KQ. Take the 2 bolts out of the skid plate near the right foot peg and pry it down enough to get to the bolt underneath, Remove that bolt and let it drain. If you have a winch you could stand it up and take the boot off the exhaust side of the CVT and let it drain that way as well.


Title: Re: how to drain water from a 2006 suzuki vinson
Post by: SWAMP_DONKEY on June 21, 2006, 03:17:37 PM
Zip Ties and Duct Tape!!!......Water from where?

what about bailing wire??


Title: Re: how to drain water from a 2006 suzuki vinson
Post by: Bigscrb15 on June 21, 2006, 03:21:20 PM
The vinsons do not need to have the skid plate removed for the CVT, just losen the 10mm bolt underneath, near the foot brake.


Title: Re: how to drain water from a 2006 suzuki vinson
Post by: VForcedave on June 21, 2006, 03:26:33 PM
Bilge pump from my moms jon boat.


Title: Re: how to drain water from a 2006 suzuki vinson
Post by: Joedirt on June 21, 2006, 03:33:10 PM
Zip Ties and Duct Tape!!!......Water from where?

what about bailing wire??

Nahh...Bailing wire could scratch the wiffle valves then you will need a can of compression just to get it started


Title: Re: how to drain water from a 2006 suzuki vinson
Post by: BCConviber on June 21, 2006, 03:35:07 PM
You also run the risk of seriously damaging a muffler bearing...


Title: Re: how to drain water from a 2006 suzuki vinson
Post by: SWAMP_DONKEY on June 21, 2006, 03:39:32 PM
You also run the risk of seriously damaging a muffler bearing...

 Sorry your right...I never thought about that or loosing all of your Brake light fluid!!!


Title: Re: how to drain water from a 2006 suzuki vinson
Post by: Bigscrb15 on June 21, 2006, 03:45:31 PM
Also if you are gonna be in the water a lot you might want to get a set of high performance cross-drilled brake lines so water won't stay in the system.


Title: Re: how to drain water from a 2006 suzuki vinson
Post by: SWAMP_DONKEY on June 21, 2006, 03:50:48 PM
Also if you are gonna be in the water a lot you might want to get a set of high performance cross-drilled brake lines so water won't stay in the system.


 Also make sure to wrap the power seat module  in some "high heat aluminium waterproof self sealing biodegradable latex tape" they have it at home depot but it is expensive, ask for it by name !!


Title: Re: how to drain water from a 2006 suzuki vinson
Post by: Da_Mtg_Man on June 21, 2006, 04:37:17 PM
The most imortant thing here is that you risk ruining the flux capacitor.


Title: Re: how to drain water from a 2006 suzuki vinson
Post by: svtbolt04 on June 21, 2006, 06:49:10 PM
The flux capacitor was on the 05, its now based around the Continuum Transfunctioner. What is that you may ask.. mystery is exceeded only by its power.. Good luck.

But, good thinking on the flux capacitor.. That would have let them go back in time and rethink the quad sinking decision.