|
Title: PRM Skid Plates Post by: MuddFreak77 on February 09, 2006, 11:04:34 AM I purchased a belly skid for my quad from them. This skid plate is BAD arse, It covers the whole bottom from the front bash plate to the trailer hitch!!!
Now for the problems: At least 4 of the holes used for mounting did not line up with the stock mounting locations. Had to file the holes out to make the alignment so I could bolt it on. Also most fo the bolts were to short, had to use a C-clamp to squeeze the plate to the frame to start the bolts. I called thier customer service and was basically told sorry you have a strange quad, these are the measurements, but we will send a call tag out and pick it up, refund you minus shipping. Why should I have been responsible for shipping when they have poor quality control??? O well just wanted to let everyone know incase they run into a similar issue. After all was said and done this is one BAD ARSE plate Freakk Title: Re: PRM Skid Plates Post by: Joedirt on February 17, 2006, 12:39:26 PM do they have a website?
Title: Re: PRM Skid Plates Post by: MuddFreak77 on February 17, 2006, 02:10:31 PM http://www.prm-atv.com/ (http://www.prm-atv.com/)
|