ATV Florida Forum

General => Open Discussion => Topic started by: Inyourdraft2000 on March 04, 2005, 01:21:14 PM



Title: Need some advice!
Post by: Inyourdraft2000 on March 04, 2005, 01:21:14 PM
I have some ITP aluminum wheels on my 4 wheeler that came w/ it when i bought it  and they gad stock Honda 400ex tires on them,,,they never ever leaked the whole time I had them...
Now I bought new tires and they keep leaking around the bead.. I have been told to put tubes in them,,,I hate to do that but if anyone has any info on why these wheels wont hold  air w/ these new tires I could use the help.. Been wanting to ride and It sucks to look at the 4 wheeler w/ flats. 8)


Title: Re: Need some advice!
Post by: Chuck_Norris on March 04, 2005, 03:11:51 PM
BREAK THE BEADS AND SEE WETHER OR NOT YOU HAVE SAND OR DIRT KEEPING THE BEAD FROM SEALING PROPERLY.


Title: Re: Need some advice!
Post by: Inyourdraft2000 on March 04, 2005, 03:55:15 PM
Well I cleaned the rims and The tire were brand new. When I pump them up after setting the beads tight to around 5#'s where they should be I can push my thumbs into the sidewalls right above the rim(beadline) and it will blow air out...they wont leak at all if i ride in a straight line,but who does that...The torque side to side is flexing the sidewall letting the air escape by the bead somehow.....I think I will end up w/ tubes before its over...


Title: Re: Need some advice!
Post by: dvx400#1 on March 04, 2005, 06:21:49 PM
hey did you try some bead locker for tires they sell it at the auto part store ??? ???