Home ATV Florida Forum ATV Florida Where to Ride? ATV Florida Links Advertise


Welcome, Guest. Please login or register.
Did you miss your activation email?

Login with username, password and session length
 
   Home   Help Search Calendar Login Register  
Pages: [1]   Go Down
  Print  
Author Topic: predator help? it wont start  (Read 10991 times)
predator trailrider
Junior Member
**
Offline Offline

Location: lakeland, mulberry

Posts: 32



View Profile

Ignore
« on: June 08, 2008, 10:40:14 PM »

i have a 2003 Polaris predator 500 i had the top end rebuilt last week of march.
i have rode maybe 6 times, last 2 times it was hard to get it started up, but once i did and it warmed up it ran as it did all the other times. last time i started it, i  rode in my yard for a minute and when i hit the throttle it kinda bogged down. i parked it and now cant get it to start.  i have changed the gas since i had the tank off to check the spark plug and to make sure it had a spark, everything was good there. when i turn it over it acts like it wants to crank at first then it just turns over. does anyone have any ideas on what it may be or anything else i should check? all help will be appreciated. i haven't rode in about 5 weeks. i need to get back on the trails
Logged
Fox17
Supreme Member
*****
Offline Offline

Location: Brevard County

Posts: 3636


Go Gators!!


View Profile WWW

Ignore
« Reply #1 on: June 09, 2008, 01:22:17 PM »

its cause its a polaris.  sorry, couldnt help myself.

if it sat for a while while it was being rebuilt or something the gas may have gone bad and gunked up the carb. if it got harder and harder it may have clogged the jets slowly until it now wont start. id take the carb apart and check it out and go from there. maybe someone has other ideas. 
Logged
predator trailrider
Junior Member
**
Offline Offline

Location: lakeland, mulberry

Posts: 32



View Profile

Ignore
« Reply #2 on: June 09, 2008, 08:49:17 PM »

i bought it like it was with the motor needing worked on.
the guy before me had it sitting about 3 months.
when i took the motor out i tore it down to the frame and had the frame gusseted and powdercoated white.
so the gas was new.
i wondering if the carb needs some kind of adjustment since i unhooked everything but i dont know anything about carbs
Logged
predator trailrider
Junior Member
**
Offline Offline

Location: lakeland, mulberry

Posts: 32



View Profile

Ignore
« Reply #3 on: June 09, 2008, 08:56:02 PM »

its cause its a polaris. 
the reason i got a polaris is because it was only 500 dollars.
now i have 1300 in it
Logged
Fox17
Supreme Member
*****
Offline Offline

Location: Brevard County

Posts: 3636


Go Gators!!


View Profile WWW

Ignore
« Reply #4 on: June 09, 2008, 10:45:16 PM »

id get a manual and set the carb to the factory settings like the idle, air/fuel screw, needle position, etc. i learned a ton about carbs by taking one apart. its really not hard and youll know everything bout them after you do it once or twice. clean the bowl and the jets out too. if you get a manual, it will show a diagram of every part of the carb. so youll know what youre lookin at.
Logged
predator trailrider
Junior Member
**
Offline Offline

Location: lakeland, mulberry

Posts: 32



View Profile

Ignore
« Reply #5 on: June 09, 2008, 10:51:10 PM »

i already have a manual . I will check into it thanks. Anyone else have suggestions that would be nice too
Logged
megapurt400
Junior Member
**
Offline Offline

Location: JAX HELL HOUNDS

Posts: 58


Do not mistake my kindness for weakness!


View Profile

Ignore
« Reply #6 on: August 01, 2008, 04:41:46 PM »

The fuel drain screw on the bottom of the carb float bowl? If it has moisture in the float bowl it will act like that sometimes, try and drain it for a few seconds and see if water comes out. make sure you catch what comes out in a little cup. If it has water it and the fuel will seperate or look cloudy, if it has trash you will be able to tell as well.
Logged
predator trailrider
Junior Member
**
Offline Offline

Location: lakeland, mulberry

Posts: 32



View Profile

Ignore
« Reply #7 on: August 02, 2008, 11:06:27 AM »

thanks for the input i will try that tomarrow as of now still not running
Logged
PREDOCROSS
Junior Member
**
Offline Offline

Location: vero beach

Posts: 63


View Profile

Ignore
« Reply #8 on: August 05, 2008, 07:00:36 PM »

Go to www.predatorowners.com. They will have you going in no time. Enjoy your pred, they are great quads. Ignore all lame remarks from those who are afraid to buy made in the U.S.A. Grin
Logged
Pages: [1]   Go Up
  Print  
 
Jump to:  

Other Florida sites of interest: www.PinballShark.com

Powered by MySQL Powered by PHP Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Valid XHTML 1.0! Valid CSS!